|
[Sponsors] |
Set up the velocity of some cells in the UDF. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 25, 2004, 08:49 |
Set up the velocity of some cells in the UDF.
|
#1 |
Guest
Posts: n/a
|
hi, all How to set up the velocity of some cells all along equal to zero in the iterations,like the WALL boundary condition?
|
|
September 25, 2004, 11:07 |
Re: Set up the velocity of some cells in the UDF.
|
#2 |
Guest
Posts: n/a
|
I thought of sending u a example but this given mail-id doesn't work...
good luck, -guru. |
|
September 25, 2004, 12:27 |
Re: Set up the velocity of some cells in the UDF.
|
#3 |
Guest
Posts: n/a
|
Thank you, guru. Please try this email address: scubme@yahoo.com.cn
|
|
September 25, 2004, 12:51 |
Re: Set up the velocity of some cells in the UDF.
|
#4 |
Guest
Posts: n/a
|
could you send it to me? thanx a lot!
|
|
September 25, 2004, 13:39 |
Re: Set up the velocity of some cells in the UDF.
|
#5 |
Guest
Posts: n/a
|
Could you send it even to me ...
Thank you very much!!! Ari |
|
September 26, 2004, 02:05 |
Re: Set up the velocity of some cells in the UDF.
|
#6 |
Guest
Posts: n/a
|
Can you send it to this mail if you explain it little bit with your code
with best regards sanjay |
|
September 27, 2004, 02:30 |
Re: Set up the velocity of some cells in the UDF.
|
#7 |
Guest
Posts: n/a
|
Would you like to send this example to me too? Thanks a lot.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 04:23 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 20:43 |
UDF velocity and temperature | Raj | FLUENT | 3 | February 1, 2009 19:29 |
How to set pressure BC with mass Velocity Magnitud | arwang | FLUENT | 2 | March 12, 2007 21:04 |
what the result is negatif pressure at inlet | chong chee nan | FLUENT | 0 | December 29, 2001 06:13 |