|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi to all. I am working on a combustion simulation case, using flamelet PDF, for which I have created a couple of UDFs. The problem is that I need to retrieve the species mass fractions and when I use the C_YI(c,t,i) an ACCESS_VIOLATION error message comes up when I try to run the case. This normally works fine when I use the Species Transport model, and I thought that the species could be retrieved using the order specified in the materials panel. Anybody has any ideas how the individual species mass fractions can be retrived in a UDF when using the PDF model? Many thanks. Regards. Fernando.
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF for Species Mass Fraction Gradient *IN SPECIFIC ZONE * -- e.g. along axis of sym. | ksiegs2 | Fluent UDF and Scheme Programming | 0 | February 27, 2011 12:55 |
UDF species equations | louiza | FLUENT | 4 | March 10, 2010 01:20 |
PB: Saving mass fraction of species on two points with an udf | biget.a | FLUENT | 2 | July 23, 2009 03:06 |
UDF for species mass fractions | MRR | FLUENT | 0 | December 29, 2005 07:14 |
UDF reading species data of pdf simulations | Jamiro | FLUENT | 0 | June 20, 2001 17:15 |