Problem in giving heat source

July 8, 2004, 03:13

Haai, For my geometry, for a voulme (3d) I am giving heat source value. When I am giving that value it is showing following message.

Error: GENERAL-CAR-CDR: invalid argument [1]: improper list

Error Object: #f

For some cases it worked successfully, but after that it is started giving problem.

If any body knows about it please tell me about this problem, because for this reason only my project has been stopped. I tried with different version of Fluent.

Thank you

July 10, 2004, 18:54

Are you applying source on one of the volumes in 3D model??? Try with small problem and check if it works fine... If it doesn't work with a small tutorial type of problem... then your fluent may have some issue...

AJ

July 8, 2004, 03:13	Problem in giving heat source	#1
Sireesha Guest Posts: n/a	Haai, For my geometry, for a voulme (3d) I am giving heat source value. When I am giving that value it is showing following message. Error: GENERAL-CAR-CDR: invalid argument [1]: improper list Error Object: #f For some cases it worked successfully, but after that it is started giving problem. If any body knows about it please tell me about this problem, because for this reason only my project has been stopped. I tried with different version of Fluent. Thank you

July 10, 2004, 18:54	Re: Problem in giving heat source	#2
AJ Guest Posts: n/a	Are you applying source on one of the volumes in 3D model??? Try with small problem and check if it works fine... If it doesn't work with a small tutorial type of problem... then your fluent may have some issue... AJ

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
source terms-convergence problem	alanlove	FLUENT	0	March 28, 2010 07:47
Missing heat source	Phil	FloEFD, FloWorks & FloTHERM	9	June 19, 2008 11:33
Heat source problem	ocy	FLUENT	7	February 17, 2005 03:08
Heat Generation as time dependent problem	Denis Kadito	FLUENT	0	April 17, 2001 17:28
UDFs for Scalar Eqn - Fluid/Solid HT	Greg Perkins	FLUENT	0	October 11, 2000 04:43