|
[Sponsors] |
Porous media with VOF ->Floating Point Error!!??! |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 25, 2004, 16:58 |
Porous media with VOF ->Floating Point Error!!??!
|
#1 |
Guest
Posts: n/a
|
Has anyone successfully used VOF and porous media? I am getting floating point errors when using porous media and multiphase flow using VOF. However, when I use only one phase I don't get the error. Could it be that Fluent's porous media cannot handle VOF?
Thank you in advance |
|
May 27, 2004, 15:38 |
Re: Porous media with VOF ->Floating Point Error!!
|
#2 |
Guest
Posts: n/a
|
I didn't try your combination of submodels, but it may well be an error in the software. There are plenty of bugs in Fluent as in any large software program, especially as the complexity of models is so large. Did you try contacting their Fluent Online Technical Support portal? It may be worth a try. Next update users will thank you, that's for sure...
Good luck George |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 03:32 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 20:08 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 21:50 |
user defined function | cfduser | CFX | 0 | April 29, 2006 11:58 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 16:16 |