LINUX CLUSTER

April 22, 2004, 16:52

I am trying to run a model that I created on windows XP platform using Fluent 6.1.22

Now I need to run my 3d model on a linux cluster. Where can I find the procedure to do so?

April 24, 2004, 05:30

Hi,

There was a webinar last week, did you attend it? http://fluent.com/direct/clustercomputing/ This event may be repeated in the future.

Some resource is available at fluentusers.com. Let me know If you cannot reach it, or find it useless, I can send you some material via e-mail.

Regards

emre

April 22, 2004, 16:52	LINUX CLUSTER	#1
co2 Guest Posts: n/a	I am trying to run a model that I created on windows XP platform using Fluent 6.1.22 Now I need to run my 3d model on a linux cluster. Where can I find the procedure to do so?

April 24, 2004, 05:30	Re: LINUX CLUSTER	#2
emre Guest Posts: n/a	Hi, There was a webinar last week, did you attend it? http://fluent.com/direct/clustercomputing/ This event may be repeated in the future. Some resource is available at fluentusers.com. Let me know If you cannot reach it, or find it useless, I can send you some material via e-mail. Regards emre

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dual Boot Windows and Linux and Go Open Source	andyj	Main CFD Forum	2	October 21, 2010 17:49
Linux Cluster Manager from SGI out for X86	Shelly Zavoral	Main CFD Forum	0	February 13, 2009 13:26
Linux Cluster Performance with a bi-processor PC	M.	FLUENT	1	April 22, 2005 10:25
Linux Cluster Setup Problems	Bob	CFX	1	October 3, 2002 19:08