 |
 |
 |
|
|
|
[Sponsors] | ||||
April 19, 2004, 09:39
|
turbulence problem
|
#1 |
|
Guest
Posts: n/a
|
I tried to find the Cd of truck (external flow). The message always showed : turbulent viscosity limited to viscosity ratio of 1.000E+05 What does it mean? My simulated result is fault?
|
|
|
||
|
April 19, 2004, 10:16
|
Re: turbulence problem
|
#2 |
|
Guest
Posts: n/a
|
this means that you have problems in convergence. lots of times i have seen it but after some iterations it vanishes.in your case you have AMD divergence error?IF YOUR PROBLEM CONVERGES THERE IS NO PROBLEM WITH THAT IN THE FIRST ITERATIONS.
|
|
|
|
||
|
April 19, 2004, 12:31
|
Re: turbulence problem
|
#3 |
|
Guest
Posts: n/a
|
Agree with STK. You may find where the turbulent viscosity is over the limit and check if the quality of your grids is good there.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| problem with UDF for (v2-f) turbulence model in fluent | artemiss1984 | Fluent UDF and Scheme Programming | 6 | January 17, 2014 06:50 |
| combustion problem | mcnair | CFX | 9 | March 22, 2011 15:06 |
| Turbulence model for mixing problem??? | nileshjrane | Main CFD Forum | 7 | September 14, 2010 05:57 |
| Inflow turbulence problem | liuzhe1213 | CFX | 0 | May 13, 2009 09:13 |
| Analyze Turbulence | Camilo Costa | CFX | 7 | December 4, 2006 12:00 |
Linear Mode
