Fatal Error Message -- CFD Online Discussion Forums

February 20, 2004, 12:20	Fatal Error Message	#1
Eric Guest Posts: n/a	Hi, When I smooth/swap a grid after gradient adapting on a combustion product such as CO2 I get a fatal error message from FLUENT. FLUENT can gradient adapt all other variables. I can Iso-value adapt the grid for combustion products, instead of using gradient adaption, without getting an error message. The initial grid is quite sparse at 100,000 cells for 3D modelling kiln. Using solution adaption for grid independence. It only seems to cause a problem when i use the gradient adaption tool on combustion products!!! Can anyone tell me why I am getting the error message when I use the gradient adaption method? Regards, Eric

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[GAMBIT] gambit fatal error	bugra	ANSYS Meshing & Geometry	2	September 16, 2010 06:19
Foam fatal error	weninb	OpenFOAM	0	June 15, 2009 23:45
Which is the fatal error when foamInstallationTest	eddy	OpenFOAM Installation	2	March 30, 2008 22:13
Fatal error error writing to tmp No space left on device	maka	OpenFOAM Installation	2	April 3, 2006 09:48
error while compiling the USER Sub routine	CFD user	CFX	3	November 25, 2002 16:16

All times are GMT -4. The time now is 05:53.