 |
 |
 |
|
|
|
[Sponsors] | ||||
February 19, 2004, 05:11
|
simulation two phase closed thermosyphon
|
#1 |
|
Guest
Posts: n/a
|
i am working on performance of two phase closed thermosyphon.can i use fluent software for simulation of two phase closed thermosyphon? thank you for recoments and guides
|
|
|
||
|
February 21, 2004, 07:28
|
Re: simulation two phase closed thermosyphon
|
#2 |
|
Guest
Posts: n/a
|
Hi; In general you can simulate some multiphase flows of some kinds in Fluent. If your phases make a continuose domain, you should use the multiphase model else, you should use the discrete phase model. I think that for your problem you should use the first option. If the surface tracking of phases is important for you, you should use the multiphase VOF model and...
Hope this help you ROOZBEH |
|
|
|
||
|
February 24, 2004, 05:33
|
heat tran simulation two phase closed thermosyphon
|
#3 |
|
Guest
Posts: n/a
|
can you help me for heat transfer simulation condensation/boiling in two phase closed thermosyhon?
|
|
|
|
||
|
November 1, 2016, 04:58
|
|
#4 |
|
New Member
Vivek Kumar Mahato
Join Date: Jun 2016
Location: Taipei, Taiwan
Posts: 14
Rep Power: 10  |
Greetings sir.. I want to simualte a two phase closed thermosyphon.. I have read various jounal papers about it..But I dont know the procedure to set up the simulation. Plz assist.. any help will be very much appreciated..Regards
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Three phase flow simulation | Gitesh P | Main CFD Forum | 1 | December 22, 2010 21:59 |
| Three phase simulation of airlift reactor | Idtisak | CFX | 0 | February 22, 2008 11:05 |
| How to simulate a closed two phase stirring vessel | Jo | CFX | 1 | November 12, 2007 17:29 |
| time and phase averaging simulation data | prem | FLUENT | 0 | December 28, 2003 23:15 |
| compressible two phase flow in CFX4.4 | youngan | CFX | 0 | July 2, 2003 00:32 |
Linear Mode
