|
[Sponsors] |
December 30, 2003, 01:07 |
3 phase Eulerian Model
|
#1 |
Guest
Posts: n/a
|
Dear ppl,
I am trying to Model Fluidized bed, with two gases namely air and CO2. In a cylinder I have considered: 1) I have made air inlet from bottom of the cylinder. 2) I have patched sand until 1/3 rd length of the cylinder. 3) I am inleting the CO2 gas at 50% height of the cylinder through the sides. Is this above simulation possible in fluent using Eulerian Model and also what are the drag laws to be considered,for the three phases considered. Thanks for your Patience, krishna. |
|
January 3, 2004, 15:20 |
Re: 3 phase Eulerian Model
|
#2 |
Guest
Posts: n/a
|
You can do this kind of simulation in FLUENT using the Eulerian model, which however isn't still able to model neither chemical reaction nor mass trasfer.
You have two gases, so you need to implement a species trasport equation using UDS, in order to calculate molar fractions of species. For gas-solid interaction you can choose Syamlal and O'Brien or Gidaspow drag law. If you have more than one granular solid phase, the only solid-solid drag law available in FLUENT is Syamlal-symmetric. You can find equations of these laws in FLUENT manual. Hi ap |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 06:36 |
Two phase Eulerian model with variable solid density | ziglat2004 | FLUENT | 0 | September 16, 2011 19:06 |
Discrete phase model in porous media | Pradeep | FLUENT | 0 | February 3, 2006 17:30 |
questions about the discrete phase model | lisa | FLUENT | 3 | January 17, 2006 08:51 |
the Eulerian model and the lower volume fraction | hx li | FLUENT | 2 | October 27, 2005 07:17 |