|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
first of all hi! I'm working on effect of distance on Natural convection between horizontal plates that are open ended and heated from below. can you tell me what are my inlet , outlet and side boundaries. what should i enter for them (like velocity inlet, pressure outlet...)? I'm looking for your messages. thx.
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
create two plates inside a big box hanging in air!!! The BC for this box would be pressure inlet and temp. and fluent would generate the velocity once you have density difference due to buoyancy...
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
dear ashu !
i've some problems again while i was solving my problem.hope you mind helping me! my problem is i couldn't generate my mesh between my parallel plates that i'm working with. can you tell me step by step the procedure to generate mesh between 2 parallel plates with GAMBIT (if you know)!. as my problem is not an enclosure (so not a volume)GAMBIT doesn't generate mesh between my plates ( or surely i couldn't manage to generate it ). hope to see your and the other peoples messages for my problem. PS:if any one make a gambit case about this problem please contact me and if possible send me! |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Handling cyclic BC from gambit to openfoam for a cascade airfoil problem - OF 1.6 | maverick | OpenFOAM Meshing & Mesh Conversion | 2 | June 18, 2011 04:36 |
Velocity profiles problem behind the elbow (3D problem) | kabat73 | FLUENT | 8 | May 9, 2010 04:26 |
periodic boundaries - flow through a net | PK | FLUENT | 0 | July 12, 2007 11:58 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |