Replace Species Conc. with UDF conc.

October 14, 2003, 08:12

hi

I want to replace the conc. of species as defined by the solver, by some UDF...so that i can insert the conc of species as per my requirement, in some part of the domain.

But I dont have any idea of the macros which i had to use.

Anyone having some idea , please reply.

By

-umesh

October 14, 2003, 08:29

Yes, I have made a number of posts about this on this forum. You can set a uds or value or source on any thread using UDF macros, depending on what you are trying to achieve. I suggest that you compare the species equation with that of the UDS with mass flux fuction, both of which are in the manual.

October 14, 2003, 08:12	Replace Species Conc. with UDF conc.	#1
umesh Guest Posts: n/a	hi I want to replace the conc. of species as defined by the solver, by some UDF...so that i can insert the conc of species as per my requirement, in some part of the domain. But I dont have any idea of the macros which i had to use. Anyone having some idea , please reply. By -umesh

October 14, 2003, 08:29	Re: Replace Species Conc. with UDF conc.	#2
Andrew Garrard Guest Posts: n/a	Yes, I have made a number of posts about this on this forum. You can set a uds or value or source on any thread using UDF macros, depending on what you are trying to achieve. I suggest that you compare the species equation with that of the UDS with mass flux fuction, both of which are in the manual.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF for Species Mass Fraction Gradient IN SPECIFIC ZONE -- e.g. along axis of sym.	ksiegs2	Fluent UDF and Scheme Programming	0	February 27, 2011 13:55
UDF species equations	louiza	FLUENT	4	March 10, 2010 02:20
PB: Saving mass fraction of species on two points with an udf	biget.a	FLUENT	2	July 23, 2009 04:06
UDF for Oxygen Conc in Porous Bed	Umesh	FLUENT	3	September 24, 2003 06:00
UDF reading species data of pdf simulations	Jamiro	FLUENT	0	June 20, 2001 18:15