|
[Sponsors] |
September 12, 2003, 05:02 |
Pure diffusion Case
|
#1 |
Guest
Posts: n/a
|
Would it possible to run a pure heat or mass diffusion case in fluent. If so please tell me the steps I should perform for running the case. Thanks in advance prasat
|
|
September 15, 2003, 01:12 |
Re: Pure diffusion Case
|
#2 |
Guest
Posts: n/a
|
I think that it is possible. You can do it by only turning-off flow variables at the 'sovle->control->solution' panel.
Sincerely, Jinwook |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
Numerical error or case error? Flow in a 3D pipe | fsalvucci | OpenFOAM | 40 | January 30, 2013 08:10 |
bc's of a komegaSST case | Zymon | OpenFOAM | 11 | July 25, 2010 10:36 |
Flux update during an MPI run between decomposed case parts? | scott | OpenFOAM | 0 | July 21, 2010 21:47 |
Free surface boudary conditions with SOLA-VOF | Fan | Main CFD Forum | 10 | September 9, 2006 13:24 |