 |
 |
 |
|
|
|
[Sponsors] | ||||
August 4, 2003, 05:22
|
interface error:poly triangulate!
|
#1 |
|
Guest
Posts: n/a
|
i'm using dynamic mesh to simulate an unsteady problem.when i create interface zone,an error appears : Poly triangulate.What's that? How to solve the problem? Is there anybody can explain it in detail? Thanks a lot!
|
|
|
||
|
August 6, 2003, 02:41
|
Re: interface error:poly triangulate!
|
#2 |
|
Guest
Posts: n/a
|
the two interfaces are not at same place.
If the two faces are in X-Y, those Z is not same! You test the two faces! This often occurs when the two face are real faces cutted. |
|
|
|
||
|
August 6, 2003, 03:09
|
Re: interface error:poly triangulate!
|
#3 |
|
Guest
Posts: n/a
|
thanks, h6h6, l try it
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
| CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 08:22 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |
Linear Mode
