|
[Sponsors] |
July 9, 2003, 19:31 |
Help: Moving a projectile through a pipe
|
#1 |
Guest
Posts: n/a
|
Hello everyone. I have questions about using Fluent 6.1 for calculation of moving a projectile through a pipe.
What from deforming mesh possibilities of the version of Fluent is better for the problem: sliding mesh model or dynamic meshes? Are there any special tutorials describing of using Fluent for such problems? Any help would be appreciated. Regards Valery |
|
July 10, 2003, 03:32 |
Re: Help: Moving a projectile through a pipe
|
#2 |
Guest
Posts: n/a
|
Hi use dynamic mesh (layering) for the same problem type.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help needed in modelling/meshing a body moving in a pipe which is driven by a fluid | hareshram.n | ANSYS | 1 | July 4, 2024 03:13 |
[DesignModeler] DesignModeler Pipe within pipe | shields | ANSYS Meshing & Geometry | 13 | November 25, 2018 23:14 |
Moving pipe | Raúl Bermejo | FLUENT | 0 | September 28, 2005 07:35 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 10:11 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 22:31 |