|
[Sponsors] |
April 17, 2003, 08:51 |
Doubt for Boundary Condition
|
#1 |
Guest
Posts: n/a
|
The model is axisymetric, Grid Check only showed the Length above Y-coordinate and the boundary condition in inlet is Velocity Inlet, I wonder that the figure of Hydraulic Diameter shoule be the diameter or the radius? Thanks a lot!
|
|
April 22, 2003, 11:29 |
Re: Doubt for Boundary Condition
|
#2 |
Guest
Posts: n/a
|
Use the real hydraulic diameter even if you're using the axi solver.
Hi ap |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
External Radiation Boundary Condition (Two sided wall), Grid Interface | CFD XUE | FLUENT | 0 | July 8, 2010 07:49 |
vorticity boundary condition | bearcharge | Main CFD Forum | 0 | May 14, 2010 12:32 |
Doubt in Inlet Pressure Boundary Condition | Sumitha | FLUENT | 3 | October 20, 2008 04:19 |
Airfoil boundary condition | Frank | Main CFD Forum | 1 | April 21, 2008 19:36 |
Slip boundary condition what is inside | normunds | OpenFOAM Running, Solving & CFD | 2 | June 4, 2007 07:45 |