initial setup question on diffusion modeling

February 15, 2003, 08:21

Hi,

I am having difficulty with setting up initial values for a diffusion model. Initially I want the room to be filled with only 50% of CO and 50% of air. Then at the velocity inlet, I will have air entering. I've figured out how the velocity inlet works - but I am having difficulty with initializing the interior conditions of the room? Any help, suggestions and advice will be greatly appreciated.

super thanks redrum

February 15, 2003, 12:12

it's okay - I figured out how to do it

February 15, 2003, 08:21	initial setup question on diffusion modeling	#1
redum Guest Posts: n/a	Hi, I am having difficulty with setting up initial values for a diffusion model. Initially I want the room to be filled with only 50% of CO and 50% of air. Then at the velocity inlet, I will have air entering. I've figured out how the velocity inlet works - but I am having difficulty with initializing the interior conditions of the room? Any help, suggestions and advice will be greatly appreciated. super thanks redrum

February 15, 2003, 12:12	Re: initial setup question on diffusion modeling	#2
redum Guest Posts: n/a	it's okay - I figured out how to do it

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SimpleFoam k and epsilon bounded	nedved	OpenFOAM Running, Solving & CFD	16	March 4, 2017 09:30
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 07:20
Error while running rhoPisoFoam..	nileshjrane	OpenFOAM Running, Solving & CFD	8	August 26, 2010 13:50
On the damBreak4phaseFine cases	paean	OpenFOAM Running, Solving & CFD	0	November 14, 2008 22:14
Could anybody help me see this error and give help	liugx212	OpenFOAM Running, Solving & CFD	3	January 4, 2006 19:07