 |
 |
 |
|
|
|
[Sponsors] | ||||
December 9, 2002, 11:23
|
line problem
|
#1 |
|
Guest
Posts: n/a
|
How to draw a line on a 3D wall? I want to draw xy pressure plot on the wall along this line. When I used Line/Rake creating Line, I found it is diffcult to draw a line on the wall? Would you please tell me how to resolve this problem, thanks.
|
|
|
||
|
December 12, 2002, 13:04
|
Re: line problem
|
#2 |
|
Guest
Posts: n/a
|
Create a Line/Rake and write the profile of pressure for it after solution is converged.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem exporting line bodies form Design Modeler to Mesh Editor&Fluent | Rockda | ANSYS Meshing & Geometry | 0 | May 26, 2011 12:03 |
| Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 03:32 |
| [Gmsh] GMSH and OpenFOAM | derath | OpenFOAM Meshing & Mesh Conversion | 44 | September 4, 2008 06:09 |
| Install problem in linux | navaladi | OpenFOAM Installation | 11 | July 17, 2008 03:24 |
| Can't see the line in Static Mixer problem. | Atit Koonsrisuk | CFX | 0 | December 17, 2002 12:56 |
Linear Mode
