Creating lines for surface integrals

October 16, 2002, 14:02

Hi to all,

I am modeling the flow in two coaxial pipes (2D axisymmetric domain), and I would like to calculate some surface integrals over the annulus only. The problem is that, if I define a line (using Surface Line/Rake), Fluent will create a line also over the inner pipe (It always creates lines from the axis to the farthest wall), even if defined the correct values of end-points' radial coordinate.

Does anybody know how to solve this issue?

Thank you very much.

Ale

October 16, 2002, 15:07

You have to use a rake where you can specify the begin- and end-points.

October 16, 2002, 16:35

Thank you very much!

Ale

October 16, 2002, 14:02	Creating lines for surface integrals	#1
Ale Guest Posts: n/a	Hi to all, I am modeling the flow in two coaxial pipes (2D axisymmetric domain), and I would like to calculate some surface integrals over the annulus only. The problem is that, if I define a line (using Surface Line/Rake), Fluent will create a line also over the inner pipe (It always creates lines from the axis to the farthest wall), even if defined the correct values of end-points' radial coordinate. Does anybody know how to solve this issue? Thank you very much. Ale

October 16, 2002, 15:07	Re: Creating lines for surface integrals	#2
Piran Guest Posts: n/a	You have to use a rake where you can specify the begin- and end-points.

October 16, 2002, 16:35	Re: Creating lines for surface integrals	#3
Ale Guest Posts: n/a	Thank you very much! Ale

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Tutorials] Tutorial of how to plot residuals !	wolle1982	OpenFOAM Community Contributions	172	December 6, 2024 07:20
[Commercial meshers] Fluent3DMeshToFoam	simvun	OpenFOAM Meshing & Mesh Conversion	50	January 19, 2020 16:33
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 18:51
creating lines normal to airfoil surface	iffy	CFX	6	July 20, 2011 07:40
Plotting Residuals	ata	OpenFOAM	12	July 8, 2011 03:50