|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello everybody.
Could you help me to run fluent 6 under Linux RedHat 6.3 operating system. After chosing 3d and parallel for 2 processors opiton and durning reading case fluent stops to working and everything collaps. It happens, when fluent builds zones and cells suddenly stops. Fluent write informations as follows: cells.., Child process died unexpectedly from signal 11 999999 (mpsystem.c@1206): mpt_read: failed: errno=104 999999: mpt_read: error: read failed trying to read 4 bytes: Connection reset by peer EOF on command stream. The fluent process could not be started I have no idea what to do whih it. Maybe one of you had got similar problem and fixed it. Please, help. Best regards. Jacek |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Aeroacoustic Problem (Modeling Flow-Induced Noise Problems Using FLUENT) | cici | Main CFD Forum | 0 | September 29, 2011 14:28 |
Problems with FLUENT MPI on i7 2600K/P8P67 | TaurusASV | FLUENT | 1 | May 5, 2011 11:58 |
Problems with Fluent | Jacek | Main CFD Forum | 2 | August 16, 2002 04:14 |