 |
 |
 |
|
|
|
[Sponsors] | ||||
August 6, 2002, 15:32
|
how to increase face mesh no.?
|
#1 |
|
Guest
Posts: n/a
|
On a particular face which am face-meshing, am not able to increase the mesh no. whatever scheme or intervals I try, what could be the reason?This is the first face being meshed.Thanks.
|
|
|
||
|
August 6, 2002, 21:29
|
Re: how to increase face mesh no.?
|
#2 |
|
Guest
Posts: n/a
|
I faced similar situation.
Did you mesh the edge before meshing the face? Could you try mesh size scheme of the face? .1, .2 or whatever you want. It should work fine. DC |
|
|
|
||
|
August 7, 2002, 05:04
|
Re: how to increase face mesh no.?
|
#3 |
|
Guest
Posts: n/a
|
When you are using tri mesh in 2d model, the maximum face number is 100,000.
This is the default value of GAMBIT. If you want to make a mesh more than 100,000, you have to change the default value. Regards, Keil |
|
|
|
||
|
August 7, 2002, 05:38
|
Re: how to increase face mesh no.?
|
#4 |
|
Guest
Posts: n/a
|
try to select the option 'remove lower mesh'
Laika, still orbiting |
|
|
|
||
|
August 9, 2002, 16:48
|
Re: how to increase face mesh no.?
|
#5 |
|
Guest
Posts: n/a
|
Hello all Thanks for your responses.It helped. Shankar.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 14:06 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
| [snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 20:43 |
| [GAMBIT] Face Mesh distortion | Forrest | ANSYS Meshing & Geometry | 0 | June 9, 2009 12:50 |
| problem related to mesh | naveen | CFX | 3 | March 25, 2006 09:47 |
Linear Mode
