 |
 |
 |
|
|
|
[Sponsors] | ||||
July 15, 2002, 13:02
|
Flame simulation
|
#1 |
|
Guest
Posts: n/a
|
Hi,
I'm new to cfd and i want to simulate a flame in a kiln. I can't get the flame to ignite. What, if there is, is the standard procedure when initialising the problem? Thanks in advance.. Mark |
|
|
||
|
July 16, 2002, 04:34
|
Re: Flame simulation
|
#2 |
|
Guest
Posts: n/a
|
You should patch a very high temperature in a small zone. This is a spark that starts your flame.
good luck, Laika, still orbiting |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GUI crash and simulation engine still running | RPJones | FLOW-3D | 2 | November 9, 2010 09:18 |
| velocity profile export from a simulation onto another | sudhirlv | STAR-CCM+ | 1 | September 12, 2010 19:57 |
| combustion bomb simulation ... | bart_weisser | FLUENT | 0 | April 25, 2010 03:41 |
| Lifted flame simulation!!! | krishh | FLUENT | 1 | August 26, 2009 06:17 |
| strange simulation error | Ralf Schmidt | FLUENT | 2 | May 4, 2007 14:02 |
Linear Mode
