 |
 |
 |
|
|
|
[Sponsors] | ||||
May 23, 2002, 10:23
|
Dimensioning dwgs with Gambit
|
#1 |
|
Guest
Posts: n/a
|
In the days of Geomesh, one could produce an output of the geometry with dimensions on it (for reports etc.). Can the same be done in Gambit?
|
|
|
||
|
May 30, 2002, 04:58
|
Re: Dimensioning dwgs with Gambit
|
#2 |
|
Guest
Posts: n/a
|
Hello,
no, in Gambit, there are no dimensions. You can scale your entire model if desired. If you read in your mesh in Fluent, you can easily scale the mesh by choosing the units that were used to create the geometry. greetings, Laika, still orbiting |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 07:29 |
| Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 13:39 |
| Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 09:33 |
| between IDL Gambit and rhino, any help? | philip | FLUENT | 0 | June 23, 2005 13:08 |
| Generating big meshes with GAMBIT on NT | Andrew Ooi | FLUENT | 12 | February 2, 2000 23:26 |
Linear Mode
