|
[Sponsors] |
April 9, 2002, 16:28 |
free surface flow past cylinder
|
#1 |
Guest
Posts: n/a
|
hi,
i am trying to sovle free surface flow past a cylinder (2D). i made the mesh in gambit with two zones of fluid, 1 for air and another for water. I used VOF scheme under multiphase. what i would like to ask is, 1. where do i specify what is water and what is air. 2. what bcs should i apply at inlet, i was giving the velocity inlet condition by specifing velocity 3. what bcs should i apply at outlet. 4. i am only interested in water flow and not air so should above condition be same for inlet & outlet of air and water. 5. i want gravity how to do that, should i enable it in operating conditions by giving acceleration value as 9.81m/sec2 in -ive y direction. 6. there is a option of enabling impicit body forces in VOF solver, should i enable it? what is it? if u can answer any of above it will be helpful. bye, vineet |
|
February 22, 2011, 00:11 |
|
#2 |
New Member
|
Dear,
Have a look at free surface flow over a bump tutorial. It is some what similar to your problem. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
flow over a cylinder urgent! | kevin | FLUENT | 8 | August 11, 2015 14:00 |
Problem with capturing water-spreading for free surface flow | devesh.baghel | OpenFOAM | 2 | December 10, 2009 02:21 |
free surface flow same as FSI??? | Ken | CFX | 1 | February 18, 2008 20:43 |
CFX 4.4 New free surface option | Viatcheslav Anissimov | CFX | 0 | April 3, 2002 07:27 |
SLAW, SWIFT, and XYZFS Free Surface flow | David willis | Main CFD Forum | 0 | April 10, 2000 01:22 |