|
[Sponsors] |
December 31, 2001, 07:28 |
Conduction in solid
|
#1 |
Guest
Posts: n/a
|
Hello, can some one tell me how to invoke conduction in the solid region? (solid has been created in Gambit and has been imported properly into Fluent.)
Regards Thejasvi |
|
January 1, 2002, 08:08 |
Re: Conduction in solid
|
#2 |
Guest
Posts: n/a
|
Just import msh file into Fluent and solve that problem. There is no special solver setting for solving conduction equation.
|
|
January 1, 2002, 11:46 |
Re: Conduction in solid
|
#3 |
Guest
Posts: n/a
|
Thanks Chiseung,I have done this..but the there is no temperature variation in the solid part...when defining boundary conditions,I have turned off the planar conduction because if that is on it gives a floating point exception..please shed some light in this direction.. Regards Theju
|
|
January 1, 2002, 20:30 |
Re: Conduction in solid
|
#4 |
Guest
Posts: n/a
|
I guess you are solving the conjugate heat transfer problem. If so, when you import the mesh file from GAMBIT, Fluent will automatically split the solid-fluid interface into the wall and wall_shadow region in your system. Try to find that your solver splitted the solid-fluid interface well and coupled option is used in a wall boundary menu.
P.S. I don't understand you turned off planar conduction but floating point execption is usually caused by the strong non-linearity of your problem. I've treated that problem by changing the relaxation factors and guessing proper initial values. |
|
January 5, 2002, 04:14 |
Re: Conduction in solid
|
#5 |
Guest
Posts: n/a
|
I hope you are putting heat source in solid! You can monitor the temperature at specific wall to check whether the temperature is increasing or not due to heat generation.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Mesh thin layer of solid cell for conduction | chingyinh | ANSYS Meshing & Geometry | 6 | December 21, 2012 01:52 |
heat conduction in solid and convection in flow | kunal | FLUENT | 3 | February 29, 2012 05:42 |
3 solid conduction | star123 | FLUENT | 0 | August 16, 2007 11:22 |
Heat conduction through solid rib in periodic duct | Dieter Fauconnier | FLUENT | 0 | October 7, 2004 09:22 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |