collision of a droplet with a solid surface -- CFD Online Discussion Forums

December 14, 2001, 07:31	collision of a droplet with a solid surface	#1
Mirko Guest Posts: n/a	Dear all, I'm tring to simulate by Flunet 5.4 an impact of a single liquid droplet onto a solid, dry and smooth surfaces. I'm using a multiphase model (VOF-GeoReconstruct) with surface tension, laminar flow, square mesh grid. Unfortunately I am findimg loads of problems in the recoiling phase. Please, can you give me some advices about this subject? Best regards. Mirko.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Solid combustion problem....	godspeedsam	FLUENT	3	May 24, 2022 05:29
droplet impact on a dry surface.... VOF again	rogerspass	FLUENT	1	June 27, 2016 03:12
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 12:05
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 13:43
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin	Kaushik	FLUENT	1	May 8, 2000 07:47

All times are GMT -4. The time now is 04:38.