Done a mesh under gambit for cylinder head and don't know if it is right!

I personally have lot many experiences of accurate simulation performed by Fluent for a water jacket geometry meshed in GMABIT.

Bipin

Hi,

I am doing a engine cylinder under gambit and studying the flow and the combustion inside.

I have done everything roughly, basically, but it works, because I am just a rouky using fluent.

To have better results, can you tell me which type of mesh do I have to set for my engine cylinder and valves (edges, faces and volumes) and why.

Moreover if you have any stuffs (address, contact, doc.) about this, feel free to send me them.

Yours sincerely, TOM.