|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi There.
I have just started modeling with Gambit pre-processor. I am setting up a problem that inclutes multiblock constrains. That is: I have a Big 3D regtangular volume and in that volume i want to set up smaller volumes.(i.e turbulent flow in a room with furniture). I am able to model air flow in the room on its own but when i add the smaller volumes into it, the smaller volumes are not regognised to be meshed. How can i constrain smaller volumes into biger volumes with gambit? Can you help me with that please? Thanks in advance. Regards costas |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Did you split the volumes? If you need both volumes split them bidirect.
Yours Armin |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Suggestions for a multi region conjugate heat transfer problem | maddalena | OpenFOAM | 14 | September 4, 2013 19:03 |
[snappyHexMesh] Multi region meshing & recovering the original patch names | fluidpath | OpenFOAM Meshing & Mesh Conversion | 4 | May 19, 2013 20:13 |
bc's of a komegaSST case | Zymon | OpenFOAM | 11 | July 25, 2010 10:36 |
Free surface boudary conditions with SOLA-VOF | Fan | Main CFD Forum | 10 | September 9, 2006 13:24 |
Multi block geometry | Samir | FLUENT | 0 | January 14, 2005 16:55 |