 |
 |
 |
|
|
|
[Sponsors] | ||||
September 6, 2001, 15:36
|
Error message in gambit
|
#1 |
|
Guest
Posts: n/a
|
Dear Sir
I tried to make wire frame surface with four real lines. But gambit gave me a following error message. ERR[7800] ACIS error 4100 : Wire has self-intersection. If there is someone who knows this meaning, please let me know. Thank you |
|
|
||
|
September 7, 2001, 11:06
|
Re: Error message in gambit
|
#2 |
|
Guest
Posts: n/a
|
make sure the four lines forms an complete loop from end to end.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 07:29 |
| Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 13:39 |
| Does Gambit has a maximum allowable grid number? | spartan1516 | ANSYS Meshing & Geometry | 7 | March 25, 2010 10:08 |
| Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 09:33 |
| Problem starting Gambit | ViHAR MALViYA | FLUENT | 0 | November 10, 2006 11:26 |
Linear Mode
