 |
 |
 |
|
|
|
[Sponsors] | ||||
December 16, 2000, 10:34
|
Reynolds no.
|
#1 |
|
Guest
Posts: n/a
|
This might be an obvious question, sorry if it is! Should the cell Reynolds no. equal the Reynolds number at which the model (airfoil) is being run? My cell Reynolds numbers are way smaller than the model Reynolds no., based on (rho)(U)(d)/mew Thanks FP
|
|
|
||
|
December 18, 2000, 11:58
|
Re: Reynolds no.
|
#2 |
|
Guest
Posts: n/a
|
The cell Re number is based in the height of the cell - so normally this value will vary from the Re one at which the model is being run.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Obtaining Reynolds Number in FLUENT | Emmanuel | FLUENT | 2 | April 7, 2016 02:46 |
| New implemented algebraic Reynolds stress model | volker | OpenFOAM | 13 | October 21, 2013 01:01 |
| Reynolds Stress Models | Jade M | Main CFD Forum | 0 | April 21, 2010 17:38 |
| Reynolds Stress Boundary Conditions | tstorm | FLUENT | 0 | July 27, 2009 15:44 |
| Reynolds stresses without velocity correlations? | Phil | Main CFD Forum | 1 | October 2, 2006 05:29 |
Linear Mode
