|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi friends: I have one problem.After every an iteration ,I want to define the quantities just above wall boundary as wall boundary conditions.Then the quantities of wall can change with the quantities of fluid.
The thread in DEFINE_PROFILE() just point to the boundary when I define boundary condition.Then I just get the quantities on the boundary.Now I still cannot get the the quantities near wall boundary before every an iteration .How can I solve it?? Thank you! Any replay will be welcome. |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to define two inlet boundary condition at the different time | nuengao | FLUENT | 0 | December 13, 2010 02:42 |
External Radiation Boundary Condition for Grid Interface | CFD XUE | FLUENT | 0 | July 9, 2010 02:53 |
how to define slip boundary condition in tube | zhucheng1980 | FLUENT | 0 | June 20, 2007 15:49 |
Free surface boudary conditions with SOLA-VOF | Fan | Main CFD Forum | 10 | September 9, 2006 12:24 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |