|
[Sponsors] |
June 28, 2000, 02:36 |
Time Dependent Solutions.
|
#1 |
Guest
Posts: n/a
|
I have a 3d geometry, and the temperature varying with time. For the solution, I requested each time step = 10 and no. of time steps = 30. After the solution, I tried to plot the temperature vs. time, but in the xy plot option I did not find any "time" option, so that I can plot against it. Where may I be wrong?
|
|
June 28, 2000, 02:43 |
Time Dependent Solutions.
|
#2 |
Guest
Posts: n/a
|
For information, I had put on the write option by going to solution > monitor > surface > for every time step.
|
|
June 28, 2000, 08:39 |
Re: Time Dependent Solutions.
|
#3 |
Guest
Posts: n/a
|
Hello I think that you cannot plot the temperature vs tim in the xyplot menu. You have to write the data in a file (monitor-->surface, write) and then plot them, or if you do monitor-->surface and plot, you should have a window with T vs time
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 12:16 |
Modeling in micron scale using icoFoam | m9819348 | OpenFOAM Running, Solving & CFD | 7 | October 27, 2007 01:36 |
time dependent MRF ? | olivier | Main CFD Forum | 1 | April 1, 2005 11:28 |
time dependent curve | faiz rauf | FLUENT | 0 | August 31, 2004 14:02 |