|
[Sponsors] |
May 23, 2000, 11:09 |
Deleting Edges in Gambit
|
#1 |
Guest
Posts: n/a
|
I've imported a iges model from Pro-Engineer and notice that the wireframe contains duplicate edges on the same edge!!
Since my model is large, is there a way in Gambit to delete all duplicate edges on the same edge? My goal is to form a volume from the wireframe, but I believe that the duplicate edges are causing my errors when I attempt this procedure. Any help would be appreciated. Alberto |
|
May 25, 2000, 10:59 |
Re: Deleting Edges in Gambit
|
#2 |
Guest
Posts: n/a
|
Hi Alberto,
When you import the IGES file, you get a dialog window where you have the option to delete duplicate edges. Choose this option and you should be alright. Be sure to set a proper tolerance as well. Good Luck. Leonard |
|
May 25, 2000, 11:09 |
Re: Deleting Edges in Gambit
|
#3 |
Guest
Posts: n/a
|
How do the tolerances effect the import process?
|
|
May 25, 2000, 11:13 |
Re: Deleting Edges in Gambit
|
#4 |
Guest
Posts: n/a
|
The tolerances are set in order to identify which edges are in fact duplicates and not just very close to each other. A tolerance set too high will delete more edges than intended. A tolerance set too low will leave a number of duplicate edges in your model.
Leonard |
|
May 31, 2000, 15:15 |
Re: Deleting Edges in Gambit
|
#5 |
Guest
Posts: n/a
|
If these extra edges are "stand alone" (i.e not part of any surface) and the model data is in form of iges surfaces, you should activate the check button for "no stand alone edges" on the IGES import form.
On the other hand if the model data is in form of edges only, you need to use "edge connect" to remove duplicate edges. You may have to use real/virtual connects with tolerance as well as tconnect depending upon the case. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 09:54 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
Strange error in Gambit while meshing edges | Ilu | ANSYS Meshing & Geometry | 1 | July 16, 2010 09:17 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 20:43 |
Edges in Gambit | Naghman Khan | FLUENT | 3 | October 3, 2007 07:36 |