 |
 |
 |
|
|
|
[Sponsors] | ||||
December 5, 2024, 04:56
|
Fluent random crash
|
#1 |
|
New Member
Join Date: Oct 2024
Posts: 3
Rep Power: 2  |
Hi everyone,
I’ve been facing random Fluent crashes when attempting to run a case in parallel. Specifically, the issue occurs while setting up boundary conditions for a perforated walls model. Fluent crashes unexpectedly during this process. To troubleshoot, I tried launching Fluent with just one processor, and it allowed me to set up the case successfully. After saving the setup, I reopened it in the parallel version, but it crashed again. *Since I don’t have an HPC license, I’m limited to using up to 4 processors. Does anyone have tips or suggestions on what might be causing this issue? |
|
|
|
|
 |
| Tags |
| fluent crash, parallel |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Unknown error when converting fluent mesh to openfoam | Yutao | OpenFOAM Meshing & Mesh Conversion | 0 | April 23, 2023 03:30 |
| Fluent UDFs crash at initialization/run with temperature & species macros | andrew-c | Fluent UDF and Scheme Programming | 3 | December 27, 2022 17:01 |
| Error: WorkBench Error: Could not handle event: SolutionStatusUpdate | Kieyo | Fluent Multiphase | 0 | November 10, 2022 00:58 |
| The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 23:56 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 10:28 |
Linear Mode
