Fluent simulation crashing everytime after 24 hrs

sanchit2208 · January 24, 2024, 13:53

I'm running some transient simulations in fluent version 18.2 on a standalone PC with parallell processing. My simulation is crashing exactly after 5100 timesteps. I am autosaving dat files after every 400 timestep. Hence, I'm able to rerun the case with the last saved file. But it again runs for next 5100 time-steps and crashes. The simulation is converging and this issue has nothing to do with flow dynamics as such.

The error in transcript file/gui is Abnormal exit when running with Workbench. If running through fluent alone, then the error message is "the fl process could not be started".

I'm sure it is not a RAM issue as RAM usage is always below 25%. I'm guessing it is some sort of a system issue as it is happening after a fixed interval, but unable to find the source. I've tried rebooting system, reducing the number of cores, etc but it didn't work.

I would be grateful if somebody can point me in right direction..

MKuhn · January 25, 2024, 07:41

Maby a network error? Connection to the licence server lost?

sanchit2208 · January 25, 2024, 10:26

I work on a standalone PC with internet connection off. Hence, doesn't think it's a network issue

January 24, 2024, 13:53	Fluent simulation crashing everytime after 24 hrs	#1
sanchit2208 New Member san Join Date: May 2022 Posts: 3 Rep Power: 4	I'm running some transient simulations in fluent version 18.2 on a standalone PC with parallell processing. My simulation is crashing exactly after 5100 timesteps. I am autosaving dat files after every 400 timestep. Hence, I'm able to rerun the case with the last saved file. But it again runs for next 5100 time-steps and crashes. The simulation is converging and this issue has nothing to do with flow dynamics as such. The error in transcript file/gui is Abnormal exit when running with Workbench. If running through fluent alone, then the error message is "the fl process could not be started". I'm sure it is not a RAM issue as RAM usage is always below 25%. I'm guessing it is some sort of a system issue as it is happening after a fixed interval, but unable to find the source. I've tried rebooting system, reducing the number of cores, etc but it didn't work. I would be grateful if somebody can point me in right direction..

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to run fluent from matlab without using aas toolbox?	artemis96	ANSYS	7	May 23, 2022 13:16
FLUENT simulation only uses 20% of the CPU speed	ALBATTROSS	Hardware	6	March 8, 2019 21:20
Start new Ansys Fluent Simulation automatically	Malue	Fluent UDF and Scheme Programming	1	October 4, 2017 02:48
Running UDF with Supercomputer	roi247	FLUENT	4	October 15, 2015 14:41
Simulation on fluent 14	NAD	FLUENT	0	September 11, 2013 03:05

January 25, 2024, 07:41		#2
MKuhn Senior Member Moritz Kuhn Join Date: Apr 2010 Location: Germany, Dresden Posts: 218 Rep Power: 17	Maby a network error? Connection to the licence server lost?

January 25, 2024, 10:26		#3
sanchit2208 New Member san Join Date: May 2022 Posts: 3 Rep Power: 4	I work on a standalone PC with internet connection off. Hence, doesn't think it's a network issue