|
[Sponsors] |
Problem in entering geometry and meshing for an airfoil in ansys fluent |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 20, 2023, 05:40 |
Problem in entering geometry and meshing for an airfoil in ansys fluent
|
#1 |
New Member
sourena
Join Date: May 2023
Posts: 6
Rep Power: 3 |
hi.i am simulating a darriuse wind turbine with flaps in 2D by ansys fluent for thesis.
i have to consider a sub domain around each airfoil to creat a good mesh.i can not do it in design modeler beacuse of that i have to use split face and i am not able to use of split face (it is not easy).so i am creating the geometry by solidworks and insert it to ansys( DWG or STP format) but every time i have a new problem like my airfoils does not shown as wall in solution setting or the flaps does not shown/i can not able to define interfaces and so on. i do not know what to do? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] gmshToFoam generates patches with 0 faces and 0 points | Simurgh | OpenFOAM Meshing & Mesh Conversion | 4 | August 25, 2023 08:58 |
Ansys Fluent - Turbulence model problem and meshing | Swish31 | FLUENT | 9 | May 6, 2020 16:39 |
FAN 3D geometry and meshing for ANSYS FLUENT | jose_1953 | CFD Freelancers | 5 | July 25, 2019 16:15 |