[michalpecz]

Not sure if i am that stupid, but why is there not some abort button in meshing and solution mode?

To be more specific, when i push - share topology i see all this warning about dihidreal violation or something and i know it doesnt have to run any further. I am however forced to either wait till process stops itself luckily afer 5 minutes, or just ctrl+alt+delete.
Same thing with solution. I make border condition but for some retarded reason its not set for normal condition defaultly but as vector ironically perpendicular for my surface, so... fluent happily says that dot product is zero, then have my wait 2 minutes without possibility to do anything... and then after deciding to stop process, IT STOP FUNCTIONING. What i mean is that i can click everything but it doesnt open any settings or actuall function.

Sorry again if its obvious, but i think abortion should be basic ability of every program, specially in theese kind of simulations.

Thanks for answer
Michal