 |
 |
 |
|
|
|
[Sponsors] | ||||
August 31, 2022, 22:41
|
cas file to Solidworks.
|
#1 |
|
Senior Member
-
Join Date: Oct 2021
Location: -
Posts: 139
Rep Power: 5  |
Hello everybody~
I have a 'cas' file and I can open it from paraview. But I want to confirm exact geometry in solidworks. How can I do? In solidworks, I can't open cas file. Below is link that enables you download my cas file. Thank you~! https://github.com/fluidko/cas-file |
|
|
|
|
|
September 6, 2022, 02:45
|
|
#2 |
|
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
you may try to write a boundary mesh, then read it
file->write->boundary mesh
__________________
best regards ****************************** press LIKE if this message was helpful |
|
|
|
|
|
 |
| Tags |
| cad, case & data fluent |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 09:46 |
| OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 07:47 |
| [swak4Foam] Problem installing swak_2.x for OpenFoam-2.4.0 | towanda | OpenFOAM Community Contributions | 6 | September 5, 2015 22:03 |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 20:43 |
| DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 02:24 |
Linear Mode
