 |
 |
 |
|
|
|
[Sponsors] | ||||
April 7, 2022, 08:34
|
Profile exceeds max bounding box
|
#1 |
|
New Member
ashkan
Join Date: Oct 2020
Posts: 17
Rep Power: 5  |
Hello, I have a question about dimension limits in ansys fluent.
It seems like when one dimension is over 500 metres, the profile will exceed the max bounding size. Here I only set a rectangular and want to extrude it. Its length is over 500m and there is an error when extruding it. How do I break this limit?[IMG]   [/IMG]
|
|
|
|
|
|
April 8, 2022, 01:39
|
large model support
|
#2 |
|
New Member
ashkan
Join Date: Oct 2020
Posts: 17
Rep Power: 5 |
I understand the problem and to be useful for everyone, I answer this question here.
before begin drawing the geometry, you should go to tool - options and in the unit section, enable the large model support. be careful: you cant enable this option in the middle of the geometry drawing. Hope this is useful |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Simulation crashes when turbulence is on (reactingMultiphaseEulerFoam) | remidemol | OpenFOAM Running, Solving & CFD | 3 | May 26, 2020 05:47 |
| Bounding k and epsilon & coldEngineFoam | sasanghomi | OpenFOAM | 1 | September 13, 2013 12:12 |
| dynamic Mesh is faster than MRF???? | sharonyue | OpenFOAM Running, Solving & CFD | 14 | August 26, 2013 07:47 |
| same geometry,structured and unstructured mesh,different behaviour. | sharonyue | OpenFOAM Running, Solving & CFD | 13 | January 2, 2013 22:40 |
| Problem with SimpleFoam for a solution around an OneraM6 wing | gara1988 | OpenFOAM Running, Solving & CFD | 3 | November 13, 2012 05:47 |
Linear Mode
