Could not select inlet/outlet boundary

syahirahshafek · January 3, 2022, 02:13

Hello I'm a student learning Ansys Workbench and I need to do CFD analysis of a nozzle. I was trying to select the inner and outlet boundaries from Inflation meshing and I wasnt able to. Can anyone help?

https://drive.google.com/file/d/1biC...ew?usp=sharing

anan12345 · January 3, 2022, 02:31

Hi, you can use named selections to help while creating / simplifiying the geometry.

As a best practice, always name inlets outlets walls or other parts where you are going to set a boundary condition or a mesh refinement

syahirahshafek · January 3, 2022, 02:34

I tried to do that but I couldn't even select and rename the inlet and outlet. Instead, it selected the whole body (highlights whole body in green)

kaboka · January 7, 2022, 09:46

Hi syahirahshafek,

you just have to change the selection method from body to face. See attached image.
https://ibb.co/JvyG9cH

January 3, 2022, 02:13	Could not select inlet/outlet boundary	#1
syahirahshafek New Member Syahirah Join Date: Jan 2022 Posts: 2 Rep Power: 0	Hello I'm a student learning Ansys Workbench and I need to do CFD analysis of a nozzle. I was trying to select the inner and outlet boundaries from Inflation meshing and I wasnt able to. Can anyone help? https://drive.google.com/file/d/1biC...ew?usp=sharing

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
CFD analaysis of Pelton turbine	amodpanthee	CFX	31	April 19, 2018 19:02
Centrifugal fan-reverse flow in outlet lesds to a mass in flow field	xiexing	CFX	3	March 29, 2017 11:00
Low Mixing time Problem	Mavier	CFX	5	April 29, 2013 01:00
domain imbalance for enrgy equation	happy	CFX	14	September 6, 2012 02:54

January 3, 2022, 02:31		#2
anan12345 New Member Join Date: Jun 2021 Posts: 13 Rep Power: 5	Hi, you can use named selections to help while creating / simplifiying the geometry. As a best practice, always name inlets outlets walls or other parts where you are going to set a boundary condition or a mesh refinement

January 3, 2022, 02:34		#3
syahirahshafek New Member Syahirah Join Date: Jan 2022 Posts: 2 Rep Power: 0	I tried to do that but I couldn't even select and rename the inlet and outlet. Instead, it selected the whole body (highlights whole body in green)

January 7, 2022, 09:46		#4
kaboka New Member Kaboka Join Date: Dec 2019 Posts: 19 Rep Power: 7	Hi syahirahshafek, you just have to change the selection method from body to face. See attached image. https://ibb.co/JvyG9cH