 |
 |
 |
|
|
|
[Sponsors] | ||||
November 21, 2021, 17:52
|
Slit zone
|
#1 |
|
Member
Adithya
Join Date: May 2021
Posts: 73
Rep Power: 5  |
Hi
I sometimes get the message ' Zone not slit' when I am changing boundary types. I looked up the documentation on mesh modification and slitting zones. I do not understand when this has to be done. Is is required if there is an interior face in a single cell zone? Which boundary types specifically require a slit zone? I am interested in defining a thin surface as a fan (for an actuator disc). Does this zone need to be slit? |
|
|
|
|
 |
| Tags |
| fluent, slit zone |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Illegal cell label -1, fluent3DMeshToFoam | BenGher | OpenFOAM | 7 | October 10, 2023 01:02 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 10:28 |
| [Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 11:52 |
| Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 18:51 |
| Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 02:08 |
Linear Mode
