 |
 |
 |
|
|
|
[Sponsors] | ||||
July 5, 2021, 06:45
|
Error in Fluent calculation on "-h100000"
|
#1 |
|
New Member
Ming
Join Date: Jul 2021
Posts: 1
Rep Power: 0  |
Hello everyone,
In the calculation case of gas transport in a three-dimensional pipeline, laminar flow transient calculation is used. The time step is about 100,000 steps, but calculation errors will occur to a certain extent. I tried to adjust the time step and some basic settings, but the same error occurs every time, and the time step when the error occurs is different each time. Any suggestion would be helpful. Thank you! "Error: out of Scheme heap space Rerun with -h flag set greater than current value of -h100000" |
|
|
|
|
 |
| Tags |
| ansys, error, fluent, transient |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to run fluent from matlab without using aas toolbox? | artemis96 | ANSYS | 7 | May 23, 2022 13:16 |
| Why my calculated epsilon is different from FLUENT calculation? | minzhang | Fluent Multiphase | 14 | May 12, 2020 23:53 |
| Calculation stop with ansys fluent windows 8 | jb pouillard | FLUENT | 3 | September 22, 2015 04:35 |
| Calculation of reaction force and moment in fluent | ldb83 | FLUENT | 4 | September 28, 2014 03:53 |
| How can I break a fluent calculation? | enry | Fluent UDF and Scheme Programming | 5 | April 5, 2010 20:18 |
Linear Mode
