Home > Forums > Software User Forums > ANSYS > FLUENT

Parametric Simulation providing the same Force outputs for each Design Point

Updated Threads

Reply

Search this Thread

March 16, 2021, 20:26	Parametric Simulation providing the same Force outputs for each Design Point	#1
Vroom_Vroom New Member Join Date: Mar 2021 Posts: 1 Rep Power: 0	Hi I am trying to run a parametric simulation to test different configurations for a rear wing on a race car. I have set up the simulation following the instructions of Old members of our team. The sim is now at a stage where it produces design points and simulates them however each DP produces the same output values for Drag and Downforce. Does anyone know how I can rectify this?

Reply

Tags

ansys, parametric, results display

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Drag force seems wrong in Cycling Shoe simulation	edomalley1	OpenFOAM	0	September 12, 2018 13:53
Force can not converge	colopolo	CFX	13	October 4, 2011 23:03
[Gmsh] Gmsh and samplesurface	touf	OpenFOAM Meshing & Mesh Conversion	2	December 10, 2007 03:27
CFX4.3 -build analysis form	Chie Min	CFX	5	July 13, 2001 00:19
Info: Short Course On Thermal Design of Electronic Equipment	Arnold Free	Main CFD Forum	0	August 10, 1999 11:18

All times are GMT -4. The time now is 16:05.