[Spiros Kouzoupis]

Hi

Last night my oc crashed so i closed everything. After i restarted fluent i imported a previous case n data. I use in my simulation dynamic mesh adapt. Before crashing i had 11000 cells after 7000 sec of simulation. After the crash after 20 time steps with 1 adapt i had +10000 cells and after 20 time steps +100000 and then crashed. Whats the problem with the adapt? Also before restarting simulation there was a message saying recommended use of warped adaption correction in solution methods. I used it and now after a while runnin again, from 11000 cells went to 68000 but now slowly decreases - 50 almost every 20 time steps. Is this a problem cause i dont use cff format for files?