|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Emmi
Join Date: Sep 2020
Posts: 3
Rep Power: 5 ![]() |
Dear all,
I have a little problem. At the moment, I'm trying to set up an 3D model of an ring-shaped 3D model. The model is pie-shaped and has an angle of 80°. I would like to simulate a swirler which has a 3 tangeltal injections. In oder to reduce the amount of nodes and computational effort, I would like to simulate the cut-out of just one injection. I found many artliches which claim that it is possible. However, it seems not possible for me. I'm using ANSYS Research R19.1. Is there a clear manual how to proceed or set upt such a boundary conditions meaning that the neighbouring "pies" (or cut-outs) behave the same? Unfortunatley, the Ansys-User-Manual didn't help me a lot. Looking forward to your answers. Cheers, fluidboy |
|
![]() |
![]() |
![]() |
Tags |
periodic bc, pie |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Speed problem of periodic boundary condition imposed on pitching airfoil. | TG777 | OpenFOAM Running, Solving & CFD | 1 | March 20, 2020 16:33 |
Turbomachinery Mass imbalance | sheaker | CFX | 12 | September 5, 2019 08:09 |
Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 06:20 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |