 |
 |
 |
|
|
|
[Sponsors] | ||||
November 16, 2020, 09:51
|
Creating named selection for inflation
|
#1 |
|
New Member
Muskan Somani
Join Date: Oct 2020
Posts: 3
Rep Power: 6  |
I am trying to model a dynamic mesh solver for a 3D elliptical pectoral fin. I want to five it heave and pitch motion by using a UDF I have created.
I want the Hex cells around the fin (created using inflation, the rest of my mesh is tet) to move with the fin. Hence I want to move those cells as a rigid passive body. However, I am unable to give that mesh a separate named selection in the solver. Therefore, I am unable to select the mesh separately. Please see the attached photos |
|
|
|
|
 |
| Tags |
| dynamicmesh, fin, inflation, namedselection, udf |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| y+ and u+ values with low-Re RANS turbulence models: utility + testcase | florian_krause | OpenFOAM | 114 | August 23, 2023 06:37 |
| [ANSYS Meshing] Script Connection Friction | arpeedesign | ANSYS Meshing & Geometry | 4 | April 11, 2019 09:17 |
| Near wall treatment in k-omega SST | Arnoldinho | OpenFOAM Running, Solving & CFD | 38 | March 8, 2017 14:48 |
| Creating named selection for a line sketch | amir00251 | ANSYS | 6 | July 31, 2012 09:02 |
| Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 21:50 |
Linear Mode
