 |
 |
 |
|
|
|
[Sponsors] | ||||
July 14, 2020, 02:30
|
Which type of interface?
|
#1 |
|
Member
vav noon
Join Date: May 2020
Posts: 49
Rep Power: 6  |
Dear friends,
I created a non conformal mesh caused to make two zones in my case. Of course both of them have the same fluid and actually must be one zone. I named two contacted faces inner and outer interfaces and Fluent identified them as interfaces. I faced a question. Should I create mesh interface in fluent? If yes, which one? I would ba so grateful if you help me. Best regards |
|
|
|
|
|
July 14, 2020, 02:34
|
|
#2 |
|
Member
vav noon
Join Date: May 2020
Posts: 49
Rep Power: 6 |
If I merge two meshes in ICEM, will it make difference?
Thank you so much |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FOAM FATAL ERROR: Maximum number of iterations exceeded: 100 | antoniomollo | OpenFOAM Running, Solving & CFD | 5 | March 2, 2023 07:13 |
| [OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 01:21 |
| Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 08:30 |
| Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 18:38 |
| Modified pimpleFoam solver to MRFPimpleFoam solver | hiuluom | OpenFOAM Programming & Development | 12 | June 14, 2015 22:22 |
Linear Mode
