Fluent Fault-tolerant Meshing surface separate problem -- CFD Online Discussion Forums

April 16, 2020, 10:10

Fluent Fault-tolerant Meshing surface separate problem

PHabib

New Member

Join Date: Jul 2009

Location: Aachen, Germany

Posts: 8

Rep Power: 17

Hello Everyone,

I'm trying out the new Fault-tolerant meshing approach in fluent, but I always end up with one whole surface mesh, e.g. the surface mesh is not separated, inlet outlet etc. are gone. I have already checked the "do you want to separate surface mesh? - YES" in the advanced options settings. I'm using fluent 2019 R3 (I have checked R1 & R2 with same problem). Attached are the geometry and the resultant mesh, which shows the problem that the surfaces are not separated.

here is a link for the sample file

https://files.fm/u/erprh9mc

Does someone has a similar problem? any help is appreciated. Thanks!

Attached Images

	geometry.JPG (43.9 KB, 9 views)
	mesh_result.JPG (95.3 KB, 8 views)

Tags

fault-tolerant meshing, fluent meshing, ftm

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] 3D coil mesh: can't create the volume?	RomainBou	OpenFOAM Meshing & Mesh Conversion	3	July 18, 2016 06:09
[snappyHexMesh] Surface problems or meshing problem?	plucas	OpenFOAM Meshing & Mesh Conversion	3	December 15, 2014 07:10
The fluent stopped and errors with "Emergency: received SIGHUP signal"	yuyuxuan	FLUENT	0	December 3, 2013 23:56
[snappyHexMesh] Layers don't fully surround surface	EVBUCF	OpenFOAM Meshing & Mesh Conversion	14	August 20, 2012 05:31
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 06:59

All times are GMT -4. The time now is 22:17.