|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Biagio
Join Date: Dec 2019
Posts: 25
Rep Power: 6 ![]() |
Why when i try to replace mesh on a case it gives me this error?
Node 999999: Process 19676: Received signal SIGSEGV. ================================================== ============================ MPI Application rank 0 exited before MPI_Finalize() with status 2 The fl process could not be started. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
|
Either the mesh has errors or the machine does not have enough RAM available
To check mesh, first load it in Fluent Meshing or Fluent stand-alone, as a fresh case. Then, run a check mesh. If it passes the test, then most likely the available memory is lesser than required. If mesh is zipped, i.e., .msh.gz, then unzip it before loading. This would require lesser RAM.
__________________
Regards, Vinerm PM to be used if and only if you do not want something to be shared publicly. PM is considered to be of the least priority. |
|
![]() |
![]() |
![]() |
Tags |
error, mesh, mpi, node |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 09:00 |
error compiling modified applications | yvyan | OpenFOAM Programming & Development | 21 | March 1, 2016 04:53 |
[OpenFOAM] Native ParaView Reader Bugs | tj22 | ParaView | 270 | January 4, 2016 11:39 |
OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |