|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Heng Kang
Join Date: Nov 2019
Posts: 2
Rep Power: 0 ![]() |
Hi, I am trying run a transient CFD model of a junction box natural convection cooling over 50 mins. It runs fine at first several iterations but after a while the energy residual keeps increasing. (see the attached pic). The current time step is 10s and only small amount of mesh with skewness larger than 0.95 (less than 10) and orthogonal quality less than 0.1 (around 300), the total mesh number is about 10 millions. Could you please provide me some suggestions? Thanks!
|
|
![]() |
![]() |
![]() |
Tags |
air cooling, natural convection |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Free surface issues with interDyMFoam for hydroturbine | oumnion | OpenFOAM Running, Solving & CFD | 0 | October 6, 2017 15:05 |
chtMultiRegionSimpleFoam turbulent case | Aditya Patil | OpenFOAM Running, Solving & CFD | 6 | April 24, 2017 23:13 |
Floating point exception error | lpz_michele | OpenFOAM Running, Solving & CFD | 53 | October 19, 2015 03:50 |
Compressor Simulation using rhoPimpleDyMFoam | Jetfire | OpenFOAM Running, Solving & CFD | 107 | December 9, 2014 14:38 |
Error while running rhoPisoFoam.. | nileshjrane | OpenFOAM Running, Solving & CFD | 8 | August 26, 2010 13:50 |