Setup for plasma Torch -- CFD Online Discussion Forums

October 31, 2019, 13:29

Setup for plasma Torch

mame

New Member

marianna

Join Date: Mar 2016

Posts: 10

Rep Power: 10

Hi to everyone,
I'm trying to do an 3D simulation of A plasma Torch, but i've a big problem with the setup: when i try to do "inizialization" i've this message (Warning)
"Info: Interface zones overlap for mesh interface contact_region_2.
This could adversely affect your solution."
I tried with an axilsimmetric simulation.
2 tube: in the first there is gas, in the second water.
The box is a FadayCage, also around the second tube.

Someone can help me???

Attached Images

Torch.jpg (55.1 KB, 8 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Taylor Couette Setup and Boundary Conditions	DaSh	OpenFOAM Pre-Processing	2	September 28, 2017 13:02
2D Glass Melt Simulation Setup	marmz	FLUENT	5	October 9, 2016 16:25
[ICEM] surface/curve mesh setup	Studi	ANSYS Meshing & Geometry	15	November 12, 2014 01:32
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 01:27
setup vof test problem	Fang Jin	FLUENT	1	June 14, 2005 09:27

All times are GMT -4. The time now is 09:29.